If pressure sensors, pressure transmitters and other field equipment are used near flammable gases or dust, they may be subject to marking in accordance with the ATEX product guideline 94/9/EC. ATEX requires the type label of the sensor to include the ATEX marking, so usually that is labelled directly onto the sensor during production.
Next to the Notified Body and the approval number, the marking of pressure sensors also contains important information for the user. For Confess , an ?X? after the approval number indicates that special conditions must be observed when using the device. These are either given in the approval document and in the corresponding manual. Most importantly, marking according to ATEX gives home elevators the possible regions of application and the type of protection useful for the pressure sensor:
Explosion group:
I Mining industry, II other areas useful Device class:
Used in zone 0/20 near von flammable gases (1G), dust (1D)
Used in zone 1/21 in the vicinity of flammable gases (2G), dust (2D)
Use in zone 2/22 in the vicinity of flammable gases (3G), dust (3D)
However, additionally, there are devices where only certain parts may be installed in other zones, for example, a pressure sensor marked 1/2G could be installed in a tank with flammable content. Unhurried of the transmitter is located on the outside of the tank, and therefore in zone 1.
Examples for forms of protection:
i intrinsic safety (Limitation of electrical ignition energy by limiting current and voltage)
ia for Zone 0 or Zone 20 (for Zone 20 also iaD)
ib for Zone 1 or Zone 21 (for Zone 21 also ibD)
ic for Zone 2 d
flameproof / explosion proof enclosure, ideal for zone 1/21 and 2/22 n
non-incendive, suitable for zone 2/22 m
encapsulation suitable for zone 1/21 and 2/22 Gas group and temperature class: i.e. IIC T1 for hydrogen
Note:
Further information on the subject of hydrogen are available on the WIKA website. Assuming Private have any further questions, your contact will gladly help you.