The versatility of Pneumatic high pressure grouting pumps

Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the free rock mass. The maximum grain dimension can not exceed 0.2 mm.
Grouting pump operation and upkeep is straightforward, secure and reliable. This pump is used in mines operating under tough conditions as a result of it is dependable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with fast release coupling and wheels.
How ราคาเพรสเชอร์เกจ works
Pneumatic stress in the air cylinder exerts a high strain on the grout mixture which leads to ejection of grout with a excessive strain and velocity. The valves of the air cylinder within the pump function routinely to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump may be pushed even without Electrical power provide in distant areas through the use of engine pushed compressor.
The pump is majorly used in building and mining industry for injecting materials into broad and medium dimension hole in beams, columns ,basement walls and flooring, carry shaft concrete wall fill-up etc. In mining business it’s used to refill cement answer the place there’s a hole exists between structure and rock and for soil stabilization.
Detachable design tends to simple maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely utilized in tunnels, coal mine, bridges and dams, constructing foundation, and different underground projects, and inflammable, explosive websites and other bad setting.
It has application in chemical business additionally to pump out chemical slurries.
The pump is electricity free so, can be used at any web site condition whether it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the ultimate amount of the grouting volume is 8 or10 occasions of the amount to begin with. And the final grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and circulate can be adjusted based on the requirements of grouting,(The flow of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electricity, development, mining etc. ground/underground development.
Mining Pneumatic Grouting pump has the benefits of low energy consumption, small vibration, low noise, small measurement, excessive efficiency, reliable efficiency, strain and circulate control, long life and so forth. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump is also Light weight and with a wheelie design it can be carried easily. It is designed for simple operation and low upkeep. Last but not least its spare elements are simply obtainable.

Leave a Comment