Peumatic Grouting pump is designed for pressure and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the loose rock mass. The most grain dimension cannot exceed zero.2 mm.
Grouting pump operation and upkeep is easy, safe and reliable. This pump is utilized in mines working under tough conditions as a end result of it is reliable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base body and stand, pressure gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How it actually works
Pneumatic pressure in the air cylinder exerts a high strain on the grout combination which leads to ejection of grout with a high stress and velocity. The valves of the air cylinder within the pump operate routinely to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump can be pushed even with out Electrical power provide in remote areas by utilizing engine driven compressor.
Applications
The pump is majorly used in construction and mining industry for injecting material into broad and medium size gap in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up and so on. In mining business it is used to fill up cement solution where there’s a gap exists between structure and rock and for soil stabilization.
Detachable design tends to straightforward upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly used in tunnels, coal mine, bridges and dams, constructing basis, and different underground initiatives, and inflammable, explosive sites and different dangerous setting.
It has utility in chemical industry also to pump out chemical slurries.
The pump is electricity free so, can be used at any web site situation whether it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally เกจวัดแรงดัน1บาร์ of the grouting quantity is eight or10 times of the quantity at first. And the ultimate grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s stress and move may be adjusted according to the requirements of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).in addition to, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electrical energy, building, mining etc. ground/underground development.
Benefits
Mining Pneumatic Grouting pump has the benefits of low vitality consumption, small vibration, low noise, small dimension, excessive effectivity, dependable efficiency, stress and circulate management, lengthy life and so forth. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it could be carried easily. It is designed for easy operation and low maintenance. Last however not least its spare parts are simply obtainable.
Share