Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the unfastened rock mass. The most grain dimension can not exceed zero.2 mm.
Grouting pump operation and maintenance is straightforward, safe and dependable. This pump is utilized in mines operating beneath tough conditions because it is reliable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with quick release coupling and wheels.
How it actually works
Pneumatic stress in the air cylinder exerts a high pressure on the grout mixture which finally ends up in ejection of grout with a high pressure and velocity. The valves of the air cylinder in the pump perform mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to finish the pumping cycle.
Pneumatic grout pump could be driven even without Electrical energy provide in distant areas by utilizing engine pushed compressor.
Applications
The pump is majorly utilized in construction and mining trade for injecting materials into broad and medium size gap in beams, columns ,basement walls and flooring, lift shaft concrete wall fill-up and so forth. In mining ที่วัดแรงดัน ‘s used to replenish cement solution the place there is a hole exists between construction and rock and for soil stabilization.
Detachable design tends to simple maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely used in tunnels, coal mine, bridges and dams, building basis, and different underground projects, and inflammable, explosive sites and different bad surroundings.
It has utility in chemical trade additionally to pump out chemical slurries.
The pump is electricity free so, can be utilized at any web site situation whether it is rural or city.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment range. Generally the ultimate quantity of the grouting quantity is 8 or10 times of the amount in the beginning. And the final grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and circulate may be adjusted based on the requirements of grouting,(The move of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electricity, construction, mining and so forth. ground/underground construction.
Benefits
Mining Pneumatic Grouting pump has the benefits of low energy consumption, small vibration, low noise, small dimension, high efficiency, reliable performance, pressure and flow control, long life and so forth. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can additionally be Light weight and with a wheelie design it could be carried simply. It is designed for easy operation and low maintenance. Last however not least its spare elements are simply out there.
Share